Visit verification
A visit only counts where the outlet is.
Check-in opens once the phone is within 50 metres of the outlet's pin. The check-in photo carries the time, the place and a verification hash, and the route is bookended by odometer photos, so a visit claimed from down the road is not a visit.
- Check-in within 50 m of the outlet
- Location-stamped photo on every check-in
- Odometer photos at start and end
Example · Check-in at Sharma General StoreOutside
120 m
You must be within 50m of the customer to check in
What it does
Visit verification, in six parts.
- Geofenced check-in
- The check-in button stays disabled until the phone is within 50 metres of the outlet, and the agent is told how far away they are.
- Photo with place and time
- The check-in photo is taken with the location captured first, and the address is looked up from the coordinates.
- A verification hash
- Each check-in photo is bound to where and when it was taken by a hash stored with the visit, so a photo cannot be quietly swapped later.
- Odometer at both ends
- A route cannot start without an odometer photo and reading, and it ends with a closing one, so distance can be checked two ways.
- Compliance on the dashboard
- The agent's dashboard shows how many of the day's check-ins were made inside the geofence.
- Works offline
- Check-ins and photos are saved on the phone and upload when the signal returns, so a basement shop still gets its visit.
Works with
See it on your own routes.
A 30-minute demo, then a pilot with a few of your agents, so you can judge FieldFlowSales on your own data.
Offline-first
No data lost when the signal drops
Native GPS
Survives app kill and battery saver
Android · iPhone · Web
Every device your team already uses
- Built on Google Cloud
- Role-based access and audit logs
- Direct founder support
